Post Created date
UPDI programmer software for Arduino - compatible with avrdude
Yes it is available on the T412 on the UPDI pin. When you configure the serial port to be External RS485 and fuse the UPDI as GPIO and then set it to be an output the USART...
Monday, 7 January 2019 - 20:08
UPDI programmer software for Arduino - compatible with avrdude
Today I etched a new carrier board and mounted a new ATTiny412 so I could plug it into a breadboard. With this fresh chip the programmer works. I suspect there is...
Monday, 7 January 2019 - 06:10
UPDI programmer software for Arduino - compatible with avrdude
Yes I see those. Both are 24.6mS with a 2mS high signal between them, followed by the the SYNCH/STCS.
Sunday, 6 January 2019 - 02:49
UPDI programmer software for Arduino - compatible with avrdude
Thanks for the response El Tangas. Unfortunately that exactly what I have tried many times without success. Having done some digging it is never getting a response from the target...
Sunday, 6 January 2019 - 01:39
UPDI programmer software for Arduino - compatible with avrdude
That's exactly what I did. After applying the 12v to the pin I can see on my scope that it is no longer a GPIO pin (it outputs a pulse 1/sec while in GPIO), also a power cycle...
Saturday, 5 January 2019 - 20:06
UPDI programmer software for Arduino - compatible with avrdude
baxsie wrote:* I have verified that I can manually use a bench supply to jam 12v into the uPDI pin to enable further programming. You will want to protect your circuitry...
Saturday, 5 January 2019 - 06:00
Problem with atmel studio 7 on a new computer.
Has anyone found a solution to this? It happened to me, I ended up rebuilding the entire PC to fix it and 2 days later it happened again.  Total PITA as I can't install any...
Friday, 3 November 2017 - 00:28
Problem with Extensions and Updates
I am having the same problem. Has anyone managed to resolve this? I have tried reinstalling, repairing etc with no joy.    Cheers Simon
Monday, 16 October 2017 - 21:00
Atmel Studio 7.0.1416/7.0.1417
meolsen wrote: We are working on updating the website. Getting there soon    Seriously? More than a month later and its still not updated!!!  How hard is it to...
Friday, 21 April 2017 - 12:56
Using a LED driver to provide PWM signals
Thanks for the reply.  Sorry, yes I should have.  It is just going to be logic pins on another cmos ic.  I should probably have also mentioned it would be a 3.3V...
Tuesday, 26 April 2016 - 11:36
Atmel Studio 7 - Version Control
So this is a real show stopper.  There is no version control support available for Studio 7 therefore I can't use it.  It's about time Atmel pulled there finger out and...
Monday, 30 November 2015 - 07:52
Where has -mshort-calls compiler option gone?
Thanks for the suggestions JW.  I was putting the -relax option in the wrong place.  I had it under compiler options not linker options.  When I put -mrelax or -Wl...
Friday, 12 September 2014 - 00:20

Pages