Post Created date
Problem with Mega32
Quote:The software what was in flash is working , but the programmer can't connect to MCU . Can you explain this? You mean the chip works but you just can't connect to the mcu? If...
Friday, 22 February 2013 - 21:46
L293E question
bobgardner wrote:Infineon BT542 drivers Google shows no result for that and a search in Infineon site shows no result either. What is the exact model ? Alex
Friday, 22 February 2013 - 14:46
High Voltage DC measurement with ISOLATION
You can use an external ADC connected to the high voltage side and transfer the result using SPI through a couple of optocoupers. In this case you only need a cheap optocoupler...
Friday, 22 February 2013 - 10:18
Using transistor to switch the power of KST-TX01
Restart00 wrote:A transistor in a common-emitter configuration is saturated when an increase in the base current produces no further increase in the collector current. The current...
Friday, 22 February 2013 - 09:22
Using transistor to switch the power of KST-TX01
Quote:So, if it isn't the gain that causes the transistor to saturate, which magical property does Unfortunately I wrote the reply too late at night so not everything I described...
Friday, 22 February 2013 - 08:03
Using transistor to switch the power of KST-TX01
Restart00 wrote:probably because the transistor has a gain >100 up to a collector current of 100mA. When you are using a transistor as a switch there is not much point to refer to...
Friday, 22 February 2013 - 01:06
Using transistor to switch the power of KST-TX01
Quote:When the base is fed with 5 Volt (Vbe = 0.73V) no connection is made from collector to emitter That doesn't make sense. A transistor biased like this is turned on, something...
Thursday, 21 February 2013 - 16:26
smd 5v or 3.3v isolated power supply....
I'm not sure where you can buy them, I originally saw them in ebay (there is a seller there). By the way I haven't used them so I can't say anything about their performance. I...
Wednesday, 20 February 2013 - 10:41
smd 5v or 3.3v isolated power supply....
I'm not sure if you refer to power supply or signal level translator. Any change that products like http://www.mornsun-power.com/cn/... may suite you ? Alex
Wednesday, 20 February 2013 - 09:14
Basic Voltage reg circuit.
I think you will be better off using a switching regulator to get better efficiency and less heat. For 24v output 4A and input of 34v you will get 40W of heat which is a lot....
Wednesday, 20 February 2013 - 08:33
Effect of modifying a read-only bit in a register
https://www.avrfreaks.net/index.p... https://www.avrfreaks.net/index.p... These two links should give enough info for bit storage in unused/auxiliary registers. Alex
Tuesday, 19 February 2013 - 10:10
Moving from Arduino to programming my own AVR... need advice
This is another nice solution for a USB boot loader, it simulates USBasp http://www.obdev.at/products/vus... I have used one of these and then flashed the USBasp program using the...
Tuesday, 19 February 2013 - 08:22

Pages