Post Created date
Gcc bug? missing castu.b in gcc 4.2.2-atmel.1.0.8
Confirmed using 4.2.2-atmel.1.0.8 from the Google buildroot fork. castu.b is missing if compiled using anything else then -O0
Monday, 26 May 2008 - 16:40
Buildroot fork
I'll help you keep it in sync if i can. I dont know about a name, but i think you should at last rename it to "buildroot-experimental". Locking it for AVR32 would be bad imo. Is...
Wednesday, 13 February 2008 - 13:38
Buildroot fork
Are you going to keep it in sync with the original tree + added packages? If so i have a few packages i would like to contribute that i have been trying to get into the upstream...
Wednesday, 13 February 2008 - 01:07
Temperature Sensor and NGW100
Thous drivers come with the kernel.
Thursday, 6 December 2007 - 18:30
Temperature Sensor and NGW100
Works straight out of the box :) You need to enable I2C support (Atmel TWI or GPIO dosen't matter). Then compile thous two drivers as modules: Maxim DS2482 I2C to 1-Wire bridge (...
Sunday, 2 December 2007 - 21:16
Temperature Sensor and NGW100
You can use a i2c to 1wire bus master, I use DS2482-100. There is a linux driver for it that works fine with avr32. It will autodetect any devices on the 1wire bus, and if you...
Sunday, 2 December 2007 - 18:06
Increasing NGW100 SDRAM
Another method is to use a hot air and tweezers. Blow on the pads on boths sides and when the solder starts flowing lift the chip of the board or push it off the pads. The...
Tuesday, 30 October 2007 - 13:58
uClibc 0.9.29 for AVR32
Excellent :D Going to test it later today. Thanks alot :)
Friday, 26 October 2007 - 15:06
LCD with U-Boot
Ahh, I have been using 1.2.0.atmel.1 and there is not LCD support there (found it to be alot less buggy then 1.1.4). Thanks :)
Thursday, 27 September 2007 - 16:06
vncserver on AVR32 ?
Dont know about any VNC servers that work on framebuffer, but i used fbgrab to test my LCD stuff before i got the LCD itself to work. It a simple solution that dosen't take long...
Thursday, 27 September 2007 - 14:33
PSIF (PS/2) kernel module
Host to device transmitting isin't used alot in PS/2, so there is a quick durty workaround for this, Swap the IO pins to GPIO before transmitting and bitbang the interface while...
Saturday, 15 September 2007 - 15:31
Best way to connect ATmega32 and USB host to the NGW?
I would connect the ATmega32 thru SPI or I2C. That way you can share the serial lines with them and also use generic linux drivers to communicate with them. I've been playing the...
Friday, 7 September 2007 - 14:20

Pages