Post Created date
NaN macros not working correctly?
You had me hopeful there for a bit, but alas it still fails.   // arm_math.h defines: #define NAN (0.0F/0.0F) float foo = NAN; // foo == nan(0x400000) uint16_t bar;...
Wednesday, 11 July 2018 - 20:40
Atmel ICE SWD Problems
Check my recent thread on this here: https://community.atmel.com/forum/atmelice-no-longer-detects-devices-error-4109-solved If the schematic matches, then make sure you check...
Friday, 5 January 2018 - 18:54
AtmelICE no longer detects devices. Error 4109 - Solved
I don't know how this could have happened, or how it ever worked before, but we looked at one of the ribbon cables from production (for AVR), and it looks like the cable I've been...
Thursday, 4 January 2018 - 22:21
Atmel ICE SWD Problems
Are there any solutions in this thread?  I'm having the same issue. 15 boards, two different SAM chips were all working fine, now none of them will connect to the Atmel ICE...
Thursday, 4 January 2018 - 21:45
SAMD21 - SPI Slave with DMA problems
Hi!  Where you ever able to figure this out?  I too am running into a similar issue where the dma isn't triggering the interrupt.  If you did, is there any code you...
Tuesday, 12 September 2017 - 15:14
input pins using ASF? -- solved
I solved this, I needed to call ioport_init(); Which I finally found mention of on http://asf.atmel.com/docs/latest/sam4n/html/ioport_quickstart.html   This also led me...
Wednesday, 16 August 2017 - 18:47
SAM4n trouble reading gpio -- solved
I solved it, I needed to turn on the PMC clock to PIOA   // get a pointer to the PMC Pmc * pmc = PMC; // enable the clock to the pioa peripheral pmc->PMC_PCER0 |= ( 1...
Wednesday, 16 August 2017 - 18:44
Optimizing problem
I too had this issue with AS5.1.148 and 5.1.208. I tried to use WinAVR-20100110, as suggested by Don, but I still got weird errors in my project, like variables that should be...
Wednesday, 28 March 2012 - 22:52
Problems with JTAGICE3: "OCD is not enabled - set the O
I'm using ATmega64. Yes, I'm sure teh jtag clock is 1/4. I'm using a 16Mhz xtal, and I've tried frequencies 1Mhz to 4Mhz. If I just use the programer (again at multiple...
Wednesday, 28 March 2012 - 20:20
Problems with JTAGICE3: "OCD is not enabled - set the O
I'm getting the same issue (and worse) on all my targets since I updated to 5.1.208. I did not have any issues with 5.1.148. Using jtagICE3, all the artifacts fail to operate when...
Wednesday, 28 March 2012 - 17:03
Syntax Highlighting and Auto-Suggestions
clawson, FYI, that doesn't work. As you state "not entirely sure what you can do if it's not shown there..." It's not there. So a uninstall/re-install looks to be required. The...
Monday, 26 March 2012 - 22:59
AVR Dragon and Debug Wire session
I'm having the same issue. I can not debug using debugwire with either the dragon nor the jtagice3 in AS5. In fact it "kills" my chips. I can not communicate with them after...
Monday, 12 December 2011 - 19:31

Pages