Post Created date
F_CPU in Studio 7
This happens for me aswell, if I build it again right after it has finished the warning goes away until I do a clean build, then it comes back again
Thursday, 24 October 2019 - 19:41
Unable to connect to tool AVR Dragon (00A20006534D)
Have you checked that the firmware is current?
Sunday, 6 October 2019 - 18:19
need to program 100+ attiny13A: which programmer board?
If your using pdip package just make a programming jig that you can hold on top of the chip while it is on board. Ie a piece of pcb with pins pointing down so they sit against the...
Friday, 4 October 2019 - 17:54
DHT11 temprature not showing
Ravoos wrote: Hello.     Hmmmmm. I don't need to define F_CPU, because it still works without it....or am I wrong?   // Ravoos I'm guessing the default value isn't...
Friday, 4 October 2019 - 15:33
ATmega128A with SSD1963
Ratchet22 wrote: Thank you for your quick reply! :)   Oh yes sure, a .h file is a header, not library, thanks:)     I used the uartlibrary from Peter Fleury and...
Thursday, 3 October 2019 - 13:40
suppress surge at the source on 120 vac house circuit ?
jgmdesign wrote: My HP1102 draws 400watts during a print job according to the specs.  The start up is higher.  For many of us in the area I live in the homes were built...
Monday, 30 September 2019 - 18:56
Using the functionality of a port: ATmega328p
ki0bk wrote: Aref should NOT be tied to AVCC, this connection can cause internal damage to the chip, the Aref pin should have a 100nf cap to gnd!   This is still a problem...
Monday, 30 September 2019 - 15:33
UART Issue Sending Hex Value
you were right, i wasn't setting up the uart properly...i sent the text and numbers in a different solution..   I had uart_init(9600);when it is supposed to be  ...
Wednesday, 25 September 2019 - 23:59
ADC Channels and JTAG
You can't program if the mcu has no power. How are you delaying the disable of the jtag in software? Are you using a delay sub routine, or do you just have it at the end of your...
Thursday, 8 August 2019 - 20:15
ADC Channels and JTAG
bbogdanmircea wrote: Ok, the JTD method seems to be working, I can disable and enable it by flashing a SW that has the MCUCR JTD change. I just need to be careful to always flash...
Thursday, 8 August 2019 - 17:17
Test A Simple ATMEGA16 LED Toggle .bin
vindicator wrote: Good point. There WAS a low probability the fuses could have changed when my SPI clocking was off, but I just added the commands to my client program and it all...
Tuesday, 30 July 2019 - 18:08
Test A Simple ATMEGA16 LED Toggle .bin
Have you changed your fuse settings for 8Mhz or are they set to default? Default speed is 1Mhz so if your delay is calculated for 8Mhz, your led will change states every 4 Sec....
Tuesday, 30 July 2019 - 15:34

Pages