Post Created date
Wiring method for homebrew CPU
Altium too will take logic schematics in and output VHDL. I dunno to me it's very counter-intuitive to hand-wire a project of that size. If you need to test some things, a partial...
Tuesday, 16 February 2010 - 20:26
Crystal format
Probably because there is no point in stocking crystals in form factors nobody will buy. HC49 is the standard for through hole, and if you are doing surface mount boards both of...
Monday, 15 February 2010 - 17:35
PCB Design - is this a bad idea?
To make your own life easier and still have good thermal coupling between the chip and the board, do make the thermal pad, but put an oversized plated through via dead center, big...
Friday, 12 February 2010 - 17:00
16-bit timer frequency problem
Something that I have not seen discussed in this thread either is the efficiency issue. You will get much better efficiency running at 20KHz than running at 200KHz, which might or...
Thursday, 11 February 2010 - 18:58
ATMega16 Project Question
I think your problem is R2. There should not be a pull down on D-, just a pull-up. Removing R2 should fix it unless there are problems elsewhere. Also the two series resistors on...
Wednesday, 10 February 2010 - 18:35
EE student
Does it not also force you to publish your own code open source under the same license if you do use some LGPL-licensed code? EDIT: Ah nevermind after verification this is the...
Tuesday, 9 February 2010 - 20:56
EE student
Is there no licensing issue with the Arduino firmware? I certainly would not go and market a product using a BASIC stamp for example, just in fear that the stamp manufacturer...
Tuesday, 9 February 2010 - 18:49
EE student
Products like the Arduino really do not have any real-life application, except from supplying you with a decent platform to learn the basics. It abstracts all the basics until you...
Tuesday, 9 February 2010 - 13:33
AVR design with Altium Designer?
All the software design tools and simulators included are for FPGA. They support a wide range of products from Xylinx, Altera, etc... There is nothing for AVR in there. Although...
Monday, 8 February 2010 - 21:45
best wireless method for this application?
clawson wrote:Quote: Also I don't know about you but a car left in gear will not start over here. Not so here - I guess that's the difference. In fact a recommended way (from AA/...
Monday, 8 February 2010 - 19:32
best wireless method for this application?
If you live anywhere close to where I live there is not even a question as to the why. When your car is parked on the street and its -30C at 6AM, you NEED a remote starter if you...
Monday, 8 February 2010 - 19:04
Does anybody focus on STM8L101+SI4432
He's asking because he has a shipment stolen from one of the ST factories in Xhyang-Huang he wants to unload. LOL
Monday, 8 February 2010 - 18:50

Pages