Post Created date
Camping Stove temperature control idea, in search of advice
Yeah, but does it have an LCD display?!? =)
Sunday, 3 February 2008 - 17:15
3.3V TTL
The problem won't be going from the 5V avr to the 3.3V or 1.8V peripheral. It's going from the peripheral back to the AVR that's the hard part. Either the AND gate or the voltage...
Sunday, 3 February 2008 - 05:36
Baud vs bits/sec?
kevin123 wrote:The way I understand it, for a simple UART, baud rate and bit rate are equivalent. Baud rate is symbols per second. For a UART, there are two symbols, high or low...
Saturday, 2 February 2008 - 17:56
Keeping a cable from pulling loose from pcb
zip ties, tyraps, zap straps, cable ties, etc, all the same thing =)
Saturday, 2 February 2008 - 02:26
Interfacing DS1307 with ATmega16
It's done with avrgcc, though, not CV, so you'll have to change it as req'd. Not that it'd compile in it's current state anyways, with half of the stuff hacked out.
Friday, 1 February 2008 - 06:59
Interfacing DS1307 with ATmega16
Here's a chunk of a project I did that's essentially everything you're looking for. You'll have to sort through it, remove all the references to records, temperature, etc and...
Friday, 1 February 2008 - 06:58
Adhesive Ribbon Cable
You'll definitely do better with glue than tape, then, I'd think. As for the right glue to get a good bond between steel and plastic, I'm not sure =/ Unless someone else here...
Friday, 1 February 2008 - 06:42
SD card missing MBR
clawson wrote:Don't always rely on E9's (JMPs) in boot/MBR sectors. In the particular disks systems I use (which aren't Intel so intel boot code would be totally pointless) the 3...
Friday, 1 February 2008 - 03:46
Adhesive Ribbon Cable
You'll probably do a lot cheaper with a roller and some glue than with double-sided tape. If you fix the roller to the table and coat it in glue, you can just roll the ribbon...
Friday, 1 February 2008 - 03:35
problems with pony programmer
More than likely there's an issue with your programmer or with the AVR. Probably nothing to do with the erase. I would get a new AVR and try that.
Friday, 1 February 2008 - 03:32
Interfacing DS1307 with ATmega16
Are you looking for someone to do this for you or are you having difficulty with a specific part? If you have the DS1307 and the AVR just stick em together and start reading/...
Friday, 1 February 2008 - 03:30
interrupt problem
I assume that means that you've set an interrupt and haven't made an appropriate interrupt handler for it. Can you post your code to show us what you've done to enable interrupts...
Friday, 1 February 2008 - 03:28

Pages