Post Created date
learnin to program in atmega16 using studio4..
There is plenty programming instructions out there, use google and search. And theres strange if atmel.com doesn't have anything But just for a short example. 1 : Connect your...
Tuesday, 8 January 2008 - 23:05
HV on RESET pin when i/o?
Okey, nice to know :) never experienced. But as you mentioned.... it's probably specified in the datasheet, along with most of the other information for a device :) Just had that...
Tuesday, 8 January 2008 - 23:00
HV on RESET pin when i/o?
the absolute voltage to I/O pins arn't that Vcc + 0.3V ? so 13V would be kinda killer :)
Tuesday, 8 January 2008 - 22:54
PROBLEM WITH TWI
you sure you send the correct adress ? if you scope the lines and everything looks OK, you should consider trying another ic
Tuesday, 8 January 2008 - 14:40
Small CPU-board
np
Tuesday, 8 January 2008 - 11:54
Small CPU-board
TQFP
Tuesday, 8 January 2008 - 11:28
Small CPU-board
I've soldiered the mega48 many times, you just need a small tip.
Tuesday, 8 January 2008 - 11:18
Small CPU-board
have you looked at the atmega48 ?
Tuesday, 8 January 2008 - 10:33
Small CPU-board
:) The Attiny is a good avr, but if you want a CPU board for development purposes you should go for a bigger avr to you have more possibilities
Tuesday, 8 January 2008 - 10:05
Small CPU-board
Quote:Change Interrupts, Pull-ups, 1 Just a comment, doesn't every AVR have pullups ?
Tuesday, 8 January 2008 - 09:55
Small CPU-board
The ATmega1281 is a good controller, I've used it lots of times. It has many ports, good ram and many interrupts. and it's possible to solder it very easily with the right...
Tuesday, 8 January 2008 - 09:43
starting out
It is essential that you know assembly to a certain level. Cause with assembly you can controll what commands are used, with C the compiler just fills them inn, and you don't have...
Tuesday, 8 January 2008 - 08:12

Pages