| Discussion Title | Created date |
|---|---|
|
RE: Configuring fuse bits in atmega128rfa1 I have a doubt regarding the configuration of the fuse bits of an atmega128rfa1. Fuse bits are programmed via JTAG Can i change the fuse bits using a c code????? Pls help me out... |
Wednesday, 23 April 2014 - 12:16 |
|
Lwmesh I have a doubt regarding the lwmesh, in most of the posts i see that users say coordinator and router and end device is that differentiation between modules is done in the... |
Friday, 14 February 2014 - 09:51 |
|
MCUSR register in bitcloud I have a requirement where on power on the device should check the status of MCUSR and if PORF bit in register is set the device should sleep,but if i read the status of bit in... |
Thursday, 9 January 2014 - 07:37 |
|
CRC calculation for wireless frame how to enable automatic crc calculation for atmega128rfa1's wireless packet and how to check it during the frame reception |
Thursday, 5 December 2013 - 05:17 |
|
RE:Flash programming How to write a single byte instead of writing a word in a page of flash. Please give an example so that i can understand easily i am using atmega128rfa1. thanks in advance |
Tuesday, 5 November 2013 - 10:01 |
|
ADC what is the maximum reference voltage that i can apply to AREF pin of atmega128rfa1 |
Friday, 4 October 2013 - 04:15 |
|
Deep Sleep mode in ATMEGA128RFGA1 Can anyone give a program to make the atmega128rfa1 to go to deep sleep mode |
Tuesday, 10 September 2013 - 10:16 |
|
Calculating the average RSSI value How to calculate the average RSSI value for ATMEGA128RFA1 |
Thursday, 22 August 2013 - 09:39 |
|
Resetting atmega128rfa1 I have to reset the atmega128rfa1 using program can anyone please help....... |
Wednesday, 14 August 2013 - 06:28 |