Discussion Title | Created date |
---|---|
Stepper Motor Help I'm working on my first stepper motor project. Things have gone well so far! I am using Mega48A on the front end that is sending step pulses to an STMicroelectronics... |
Monday, 17 November 2014 - 21:12 |
Intermittent USART Issue - ATTiny2313a I'm using an ATTiny2313a for a project that has an RS232 output a very basic, repeating string. The string starts with a 'K' each time and is followed by 34bytes of data (16... |
Monday, 5 September 2011 - 21:39 |
Ext. int. not working at start up if frequency on input I've done a few projects were I've monitored pulse width with an ext. int. Over the projects I have noticed that if I have my frequency generator applying a frequency (10hz say)... |
Friday, 8 May 2009 - 15:11 |
Embed secure ESN in to AVR I'm currently working on a project that requires an internal unique random number (ESN). This number will be the basis of a secure link between two seperate devices where the... |
Monday, 16 March 2009 - 15:00 |
Polarized Relay Coil - Diode needed? I'm using this DPDT relay - http://pewa.panasonic.com/pcsd/p... The datasheet states that the coil is polarized, but the schematic shows a simple coil. I'm guessing that the coil... |
Monday, 17 March 2008 - 02:38 |
DebugWire Issue - ATMega48 w/ ext. osc. I'm using the DebugWire interface for the first time. The chip at hand is the ATMega48 and I'm using the Dragon as my interface. I got everything working great, including the... |
Saturday, 22 December 2007 - 17:25 |
Batch programming with the Dragon Is batch programming possible with the AVRDragon? I have batch files for many different projects for my STK500 and I would like to be able to use them to program chips with my... |
Saturday, 24 November 2007 - 20:07 |
Lock Bits - Tiny45 I've noticed on the Tiny25/45/85 that if you enable the lock bits that it locks the EEProm as well. Is there anyway to protect the flash contents while still allowing the EEProm... |
Monday, 12 March 2007 - 02:09 |
Problem using Reset as Input Hi everyone, I've been working on an pulse monitor circuit for a while now based on a Tiny12 AVR and everything was working perfect, until I decided to raise the frequency to... |
Tuesday, 29 March 2005 - 01:34 |
Using 12VDC Solenoid as input Hey guys I have encountered an AVR problem that I hope someone can help me with. I am using an Atmel Tiny12 to monitor door lock pulses in a car. The door lock actuator is a 12... |
Tuesday, 30 March 2004 - 19:37 |