Post Created date
Counter at the Tn Pin, can't figure out how it works
meslomp wrote:Quote: Thanks Jim! then Im correct about that the T1 corresponds to the one that will be used in case Im using Timer1 ... Correct? It might be that on a single...
Monday, 4 June 2012 - 19:07
Counter at the Tn Pin, can't figure out how it works
ka7ehk wrote:Check the block diagram for the counter. I think you are correct but not absolutely true. By the way, none of us have "memorized " the specification sheets. All of...
Sunday, 3 June 2012 - 03:30
Counter at the Tn Pin, can't figure out how it works
ka7ehk wrote:Atmel tend to use notations such as PORTn to refer to a generic register that has several instances. It is up to you to substitute the correct number instead of "n"....
Saturday, 2 June 2012 - 21:59
Counter at the Tn Pin, can't figure out how it works
ka7ehk wrote:For the timer that has the T1 pin, go to that timer chapter in the specification sheet; Go to the register descriptions at the end of that chapter. There, you will...
Saturday, 2 June 2012 - 20:53
Reading a single bit.
Well at the end I didnt use the sbit.h lib instead I use masking, but here is the end code if some one has the seam problem from reading a matrix keyboard. Sorry about the dealy,...
Thursday, 3 May 2012 - 20:32
Reading a single bit.
clawson wrote:Read that bit manipulation 101 thread as far as page 6 and "danni" (Peter Danneger) posts his sbit.h which casts a bitfield onto any memory or IO location you choose...
Saturday, 28 April 2012 - 14:54
Reading a single bit.
bobgardner wrote:Now go edit the misspelled thread title for the benefit of other folks? Correct!! never saw it.. sorry about my english, every marked error is apreciated! you...
Saturday, 28 April 2012 - 01:58
Reading a single bit.
Well Thanks to all the answers! at the end I use a mask PORTB & 0xf0, that to ensure the value of the low nibble. And it is working just fine.. Now, is it possible to make a...
Saturday, 28 April 2012 - 01:56
Reading a single bit.
js wrote:I have the idea that you should post in the correct forum. :-) I'll move the thread. Also see the "bit manipulation" tutorial in the tutorial forum. edit I see you are...
Saturday, 28 April 2012 - 01:50
STK600 + studio 5.1 cant start debugging
Ok, I will check it out and come back if there's something else to comment. I apreciate a lot both of your answers. Thankyou!
Sunday, 22 April 2012 - 16:13
STK600 + studio 5.1 cant start debugging
JohanEkdahl wrote:Quote: how can I debbug using the stk600?? You can't. The STK600 is not a debugger. You either run your code in the simulator (with it's shortcomings), or you...
Sunday, 22 April 2012 - 14:25
[TUT] [C] Bit manipulation (AKA "Programming 101")
clawson wrote:I think this tutorial is trying to be as generic as possible. Not all the AVR C compilers have all the bit names defined in the header files for each AVR part so...
Thursday, 19 April 2012 - 01:01

Pages