Type in the full discussion title or a part of it.
Discussion Title Created date
Clarification on what's "legal" to post
I have seen other posts in this section on Nordic wireless chips. I've also read the sticky posts here and it's not 100% clear that you can ONLY post about Atmel wireless products...
Thursday, 13 March 2014 - 20:42
Favorite PCB vendors?
Ready to do a proto run of 10 2-layer thru-hole boards. Have used ElectroFreaks before with good success and the lowest price I could find. Just got a quote back from SpeedyPCB...
Friday, 3 January 2014 - 16:24
RESET/ pin with debugWire and an external interrupt source
In the hunt for just one more ATmega328 line that can be used as an external 0-level interrupt input I'm wanting to use the RESET/ pin. The user guide defines the RESET/ pin as...
Friday, 27 December 2013 - 16:02
(Yet another) Input protection question
I'm designing an input circuit for a mega328 ADC input to read a variety of external position sensors that use a 360 degree pot (pots range from 1k to 20k depending on vendor)....
Thursday, 5 December 2013 - 04:34
Graphics Overlay vendors
I'm using inkjet-produced graphics overlays for prototypes and they work great but now I need to find a source who make them in small runs (~25 per order). The bare aluminum panel...
Sunday, 28 July 2013 - 21:11
Switches-on-PCB problem
Early in this (multi-unit) project I had intended to mount tactile switches directly on the PCB and then mount the PCB up against the front panel. This would have allowed switch...
Sunday, 30 June 2013 - 04:36
Enclosure w/ hinged door?
I'm at wits end trying to find a vendor for an off-the-shelf outdoor equipment enclosure like this one only smaller (~6"x5" or anything close). No need for NEMA or UL ratings just...
Thursday, 23 May 2013 - 14:20
External INTx latching behavior
Using ATmega328. Have a question about External INTx behavior when falling edge is selected. Does the AVR normally latch an external falling edge int even when you have the...
Thursday, 2 May 2013 - 17:18
JTAGICE3 + AS5: no downloads or execution breaks
Using JTAGICE3 with AS5. Both have latest updates. My target is mega328p on an Arduino Uno. I'm able to develop and download programs from AS5 after adding an External Tool button...
Thursday, 15 September 2011 - 19:42
JTAGICE3 and AS5: No Breakpoints
Just got a new JTAGICE3 today, updated the firmware, and tried it with the latest AS5 (5.0.1163). Will not halt at any breakpoints. This has been reported as a problem months ago...
Wednesday, 14 September 2011 - 01:58
JTAGICE3 and Arduino Uno problem [solved]
Am trying to get a new JTAGICE3 working with an Arduino board via the 6-pin SPI connector. The JTAGICE3 pinouts for that connector match up to pins on the Arduino Uno schematic...
Tuesday, 13 September 2011 - 23:17
Undefined references [solved: overuse of static]
I have C/C++ programming exper but am just getting started with AS5. Have built a small library with 2 .c files as one lib solution then built a v-e-r-y simple test program as an...
Saturday, 10 September 2011 - 02:49

Pages