Post Created date
Atmega16 & reading AD7688
I dont understand your code... what is the second temp <<=8; for??
Saturday, 23 February 2013 - 10:52
STK600 Xmega sometimes verify fails with Atmel Studio 6
Are you upgrading the firmware of your STK600 when switching between studio 4 and studio 6??
Wednesday, 20 February 2013 - 16:48
Return from PCINT1 ISR restarts program
Can you read the Fuses and post it here?? or read the MCUSR and find out what the reset cause is...
Tuesday, 19 February 2013 - 16:54
trouble with _delay_ms function
_delay_ms(5000); The accuracy of delay will go bad when you start using delays greater than "262.14 ms / F_CPU in MHz."... So If you are looking for precise delays, then go...
Tuesday, 19 February 2013 - 16:44
Timer
I will start of with something which might make this code look more sane to you.... When you call this clockInit(), you are providing a clock to the Timer.. as soon as you do this...
Sunday, 17 February 2013 - 07:31
KeyMatrix
Since it is working.. No issues.. I would like to know in which part of the code, you set PORTH as input and enable its pullup... Regarding a poor glowing.. How is the LED...
Saturday, 16 February 2013 - 11:21
q: how to extract program
Theoretically it is feasible to re-construct the assembly instructions from the binary knowing the device family and architecture... but It will def be difficult, you can as well...
Thursday, 14 February 2013 - 17:44
ASK: Lifetime ATMega16 & Xbee for 24hours running
Nothing is impossible. You can really run zigbee (it is a low power app) for a big amount of time. Just need to take care of the batteries (Battery monitoring) and sleep modes....
Monday, 11 February 2013 - 17:01
transformer less power supply for micro-controller
Transformer less power supply?? What is the input you have? How much load you expect on the other side? If it is AC, then whatever you build to convert that from AC to DC will be...
Sunday, 10 February 2013 - 04:20
Trouble Programming an ATMega8 After Burning Low Fuse
Quote: I looked at the diagram, can't you see the dry joint on AVCC? The def of dry joint from wiki Quote: dry joint is a type of badly soldered joint in which the solder failed...
Sunday, 10 February 2013 - 03:39
2560 problem
js wrote:Quote:No, big issues with the schematics.So you don't think that using 100nF with the crystal is a big issue? :) Tat is a bad!.. :oops: but that has nothing to do with...
Sunday, 10 February 2013 - 03:27
ISP MISO is not being pulled low properly...
Is there someone else sharing the MOSI, MISO lines along with the ISP programmer? Better post the schematics...
Saturday, 9 February 2013 - 18:35

Pages