Post Created date
Atmel Studio 6.1 Beta released
ezharkov wrote:Quote:Command line utility for firmware upgradeWhat is this, exactly? Is this a new atprogram feature? How can one get hands on this thing without a full install?...
Saturday, 9 March 2013 - 09:28
SKT600 and AVR studio 6.1
Can you see the STK600 enumerated in your PC.. Just go to device manager and check whether it is available in the Jungo class.. If there is a yellow colour exclamatory mark over...
Saturday, 9 March 2013 - 09:08
Burn bootloader and a program at the same time
what about programming the bootloader and use the bootloader to program the application. By that way you can also ensure that the bootloader is also working.. ;)
Saturday, 9 March 2013 - 09:03
Master and Slave SPI
See the attached image for how the protection diodes are there inside a chip[/img]
Saturday, 9 March 2013 - 08:50
Input protection diodes on Atmel port pins
There is an app note from Atmel describing how to do this http://www.atmel.com/images/doc2... Take a look at it.. But I think you definitely need some components on the board, I...
Saturday, 9 March 2013 - 08:38
this code is not working
dont exit out of the main loop.. stay within there... int main(void) { usart_init(); // initialization of USART while(1) { value=usart_getch(); // get data from serial...
Saturday, 9 March 2013 - 08:33
ATmega644P TWI Start Condition Hanging
Have you checked the address (0xDE)? it doesnt look 7 bit...
Thursday, 7 March 2013 - 17:08
UART/HyperTerm: I *THINK* This Is a New One
Also you can spend time to probe the TX/RX lines of the UART to see what is actually on the line.. you can verify all your claims in that...
Thursday, 7 March 2013 - 17:00
creating "empty" .hex file
Just for the sake of completion of the info. Chip erase will make the contents of flash FF not zeros
Tuesday, 26 February 2013 - 03:12
Atmega32u4 Development Board
Some things which occured to my mind, --> Please support debug interface, ATmega32U supports debugWire interface. If you have to do that.. then the cap on the reset lines have to...
Sunday, 24 February 2013 - 17:18
VBUS sensing schematic
what is the objective??
Sunday, 24 February 2013 - 08:07
Atmega16 & reading AD7688
Can you post the connection or wiring diagram... What mode is the ADC connected? What I thot was you get 2 bytes from the ADC and you are shifting 16bits so obviously you lose the...
Saturday, 23 February 2013 - 15:11

Pages