Post Created date
XMEGA-A1-XPLAINED kit connectivity problem
1. Jtag header is connected properly? 2. Try reducing the JTAG clock to as low as possible and try
Monday, 1 July 2013 - 14:30
Using dual I2C interfaces (TWI and software) on atmega?
There is still no need. For implementing 2 I2c afaik. We can change thru baud and have a single master and multiple slave. That is what those interface is meant for isn't it?
Monday, 1 July 2013 - 03:04
DDRx Addresses
I do that in most of my codes and haven't faced any issues so far
Monday, 1 July 2013 - 02:57
ATMega256RFR2 Xplained + AVRDude?
alexru wrote: It also seems like you are trying to connect to the Virtual COM Port, it is not the device you are looking for :) programming USB interface identifies itself as EDBG...
Sunday, 30 June 2013 - 06:33
Atmel Studio 6.1 Assembler/Toolchain Problem
Quote: C:\Atmel Studio 6.1\ Are you sure this is the place studio is installed? and the compiler exists in that place??
Sunday, 30 June 2013 - 04:15
atmega SPI hardware
and moderators, I think this is probably in the wrong forum... So please move it :)
Sunday, 30 June 2013 - 04:05
Programming xmgea with bootloader
if your board has buttons, you can tweak the bootloader source code to wait for firmware upgrade on button press (provided you have the source) :)
Sunday, 30 June 2013 - 04:03
atmega SPI hardware
In the gcc version I have (atleast) these DDRB, PORTB are defined in a header file called, io***.h.. So Please check whether you have it there included in your project..
Sunday, 30 June 2013 - 04:02
ATMega256RFR2 Xplained + AVRDude?
For the starter, the board is called as Xplained Pro, if it has the EDBG interface. My best bet is that, you flash a UART bootloader in the Mega256RFR2, (Yes use W**dows) to do...
Sunday, 30 June 2013 - 03:32
Why compiler error for this code
Wrong way of calling delay function. Shouldn't be a square bracket
Thursday, 27 June 2013 - 13:49
Does not connect or see debugger w SAM4L Xplained Pro
And just start studio and plug in the device. It should show a start up screen. Tat u have plugged in a Sam 4l device
Thursday, 27 June 2013 - 13:40
Does not connect or see debugger w SAM4L Xplained Pro
just open the Hid tab. you will find a device 03eb. that is the debugger. it is a composite device. dis you check in device program dialog ?
Thursday, 27 June 2013 - 13:31

Pages