Post Created date
AVRONE and AS6 problem
Hi, I have been using AVROne and had similar issue on xmega board. However, I just recently found that if you fold cable between AVRone and target device to make the entire length...
Tuesday, 4 February 2014 - 04:52
XMEGA / Cascading timers using event system
I found the solution. - TCC1 counts the number of pulses out of TCC0 via. event system - When TCC1's count reaches the target value, DMA writes zero to TCC0's clock selection...
Tuesday, 4 February 2014 - 04:25
XMEGA / Cascading timers using event system
Hi, Thank you for your feedback, again. I have a FPGA connected to xmega. The xmega sends strobe pulses out of OC0A to FPGA. FPGA sends data to xmega each time it receives the...
Monday, 27 January 2014 - 17:48
XMEGA / Cascading timers using event system
Hi All, Thank you very much for your suggestions. It is working now. However, one more thing I would like to ask you. Is there any way to stop TCC0 immediately after TCC1’s...
Monday, 27 January 2014 - 02:19
ATxmega256A3BU-xplained / clk_per selection
I got it! By the way, the chip is not hot at all for at least my application. Anyway, thank you for your response.
Sunday, 26 January 2014 - 04:29
Unable to set breakpoints in Studio 6
Hi, I just started using Studio6 w/ AVR one and had the same problem. When I changed the otimization level to "none", the problem was solved. I don't know about a reason.
Thursday, 22 November 2012 - 23:30
TINY10 / Store constants in flash memory and use them
Hi, Thank you very much for your response. I will try ASM or check other compilers to see if they work. Thank you.
Thursday, 1 December 2011 - 01:33
XMEGA32A4 / DAC's external reference source at PB0
Hi, everybody Thank you for your responses. Yes, I had the caps at both PB0 and AVCC pins. However, I encountered another problem that PDI programing occasionally stops working....
Thursday, 21 July 2011 - 18:08
XMEGA32A4 / Production Signature Row
Hi, Thank you very much for your inputs. I also found the AVR1316 describing about how to read calibration data. Your code example is better. Thank you.
Tuesday, 10 May 2011 - 13:11
XMEGA32A4 / Production Signature Row
Hi JC, Thank you very much for your help. It is indeed well hidden. I hope Atmel update about the manual or create a separate document about those soon. Thank you very much.
Tuesday, 10 May 2011 - 04:45
XMEAG32A4 I/O pin's slow rise and fall transition
Yes, I am aware of it and thank you.
Tuesday, 10 May 2011 - 03:48
XMEGA32A4 / Production Signature Row
Hi JC, Thank you very much for your suggestion. I was looking at XMEGA A manual and so far found two calibration data's offset address, 0x24 and 0x25 for ADCBCAL0 and ADCBCAL1...
Tuesday, 10 May 2011 - 03:47

Pages