Post Created date
1.8v device on a 3.3v circuit used this on some of my projects Cortex-A8 @ 1.8V xmega16 @ 3.3V...
Saturday, 24 March 2012 - 16:11
Periodically waking xmega from sleep?
you can run the WDT in interrupt mode
Sunday, 18 March 2012 - 14:10
Interrupt USART xmega - RX_vec does not fire, why?
dont forget to clear the TX flag after echoing it USARTD0.STATUS &= ~(1 << USART_TXIF_bp);
Monday, 5 March 2012 - 16:44
XMega32A4 and AVR Dragon
unfortunately, I covered my PDI programming wires with heatshrink so I cannot look into it
Sunday, 4 March 2012 - 16:37
XMega32A4 and AVR Dragon
Its the same issue I was having before, dragon PDI unable to talk to xmegaXX series properly I read somewhere in the forum to add a series resistor to the CLK and DATA line, I don...
Sunday, 4 March 2012 - 16:36
Need help for Xmega I2C and SPI programming
tried it on xmega16D4, xmega32A4, xmega128A1(xplained board) and all works fine.
Monday, 13 February 2012 - 08:45
Need help for Xmega I2C and SPI programming
I've never had problem using SPIC on my projects using AVR Studio 5 or the beta 5.1. Maybe you got the programming wrong or you have a bad board
Monday, 13 February 2012 - 07:42
Ethernet Cable
Buy a cheap switch
Thursday, 9 February 2012 - 09:04
about uip
DHCP is but not ICMP. It is itself a layer 4 protocol that rides on IP. You can send data over UDP but you would have to provide error recovery at a higher layer (i.e. in your...
Monday, 17 October 2011 - 06:06
WiFi / Bluetooth modules?
Not to hijack this thread but I have one of those cheaper Microchip WiFi module (ZG2100MC) and I can't find a reference manual/programming manual/etc online. It has been sitting...
Thursday, 13 October 2011 - 08:23
DAC output for XMEGA-A1 Xplained kit?
its on PB2
Friday, 30 September 2011 - 04:53
String Parsing
I think the problem is in the switch-case-statement, you cannot use "string" values for comparison. case "up" case "down" case "etc" only case 1 case 2 case 3 case int case 'a'
Thursday, 29 September 2011 - 08:28