Post Created date
An error occurs when I add ISR routine cord
hi all,   I found an article about ISR of uCOS. https://www.avrfreaks.net/forum/how-design-rx-buffer-ucos-ii   When They made the routine of the interrupt signal called...
Sunday, 12 March 2017 - 10:51
An error occurs when I add ISR routine cord
hi awneil,   Thank you for your reply.   I just knew the meaning of ISR  LoL   Thank you
Wednesday, 8 March 2017 - 09:10
An error occurs when I add ISR routine cord
hi js,   Thank you for your reply. Accroding to iox128a1.h   I confirmed such a description. /* SPIF interrupt vectors */ #define SPIF_INT_vect_num 118 #define...
Wednesday, 8 March 2017 - 09:06
I can't download firmware by JTAGICE3 in AVR Studio7
Hi js, Thank you for your reply.   I don't know it whether it is firmware Version necessary that  I use JTAGICE3 in AS7.   The message box of the update advice of...
Wednesday, 21 September 2016 - 08:30
Build Error when I changed the project of xmega128a1u to xmega128a1
Hi,clawson Thank you for your reply.An answer becomes slow and is sorry.
Friday, 16 September 2016 - 02:15
Build Error when I changed the project of xmega128a1u to xmega128a1
Hi,Mandar Joshi  Thank you for your reply.An answer becomes slow and is sorry.  
Friday, 16 September 2016 - 02:14
I can't communicate ATxmega128A1 and JTAGICE3 after writing the fuse bit.
hi js,   Thank you for your reply. I would like to check BOD well.   thanks.  
Wednesday, 29 July 2015 - 01:28
SOLVED: Firmware download is not possible to ATmega88P by JTAGICE3
Hi Jim,   An answer becomes slow and is very sorry. It was able to be settled. When alcohol washes a connector part of the cable of JTAGICE3; with the debugger came to...
Monday, 29 June 2015 - 00:37
SOLVED: Firmware download is not possible to ATmega88P by JTAGICE3
Hi Jim,   Thank you for your reply.My target board have ATmega88 and CC1101(ti's device) for the wireless communication. The tip is listed with "MEGA88PA".  ...
Tuesday, 9 June 2015 - 02:53
ATxmega128A1 did not work during BOD LEVEL change.
Hi JC, Thank you for your reply.I have discarded some ATxmega128A1 by setting of this BODLVL. But a cause became clear I think.   Thank you for your advice.    
Friday, 8 May 2015 - 01:49
ATxmega128A1 did not work during BOD LEVEL change.
Hi, Rezurok   Thank you for your reply. After ATxmega128A1 with ATxmega128A1U the writhing setting of BODLVL , I understood...
Friday, 8 May 2015 - 01:44
I can't communicate ATxmega128A1 and JTAGICE3 after writing the fuse bit.
Hi JC, Thank you for your reply. After inputting the VCC voltage around 3.4V from the outside, I was able to communicate in JTAGICE3.   BODLEVEL was slightly strange that it...
Tuesday, 21 April 2015 - 09:10

Pages