Post Created date
Pairing issue with AT86RF231
Hmm, how about this - from main, try calling pal_timer_start with some known timeout. In the expiry handler callback, toggle a pin and restart the same timer with the same timeout...
Friday, 20 April 2012 - 14:03
Pairing issue with AT86RF231
You mentioned using a non-atmel micro, so are you sure the timers, etc. work fine on your platform?
Thursday, 19 April 2012 - 10:21
Bitcloud Data transmission...
gopikrishnan wrote:Is the 250kbps defined by zigbee is a standard or it can be changed based on the platform? This data rate is the theoretical maximum possible from the 2.4GHz...
Thursday, 23 February 2012 - 05:04
Zigbee coordinator role...
ma5645 wrote:2. Let assume, that the network is formed and running, including Routers (m) and EndPoints (n). They formed the mesh, which basically reliable regarding the router...
Thursday, 22 December 2011 - 06:40
[solved] problem using uart
rugebiker wrote:but that also gave me a lot of chunk data =/ The checking of status flag must be done inside the while loop, either before or after writing the character to the...
Wednesday, 23 November 2011 - 06:21
Basics of Zigbee
Like others mentioned, trying to make a node running the Atmel MAC communicate with a Telegesis dongle might not get you anywhere.. At best you may be able to do a MAC level...
Wednesday, 23 November 2011 - 05:03
Where do I get a MAC address from?
Quote:Yup. Told you above that I'm not here at Wireless often, and I just displayed my ignorance assuming we where talking MAC-48...Most of what you said applies here too though..
Tuesday, 22 November 2011 - 08:25
AVR Benchmark
bobgardner wrote:This site says their 8051 variant is 3600 faster than the original 8051, and does 6.5 dhrystone mips/mhz, so its 2 times...
Tuesday, 22 November 2011 - 05:15
RF4CE + STK600 + ATmega128RFA1
Gateway wrote:if needed i can post the code that I tried so far...although without success.I guess that might be a good idea, unless you've solved your problem already..
Tuesday, 22 November 2011 - 04:44
Where do I get a MAC address from?
JohanEkdahl wrote:If you need MAC addresses you buy a series from IEEE. MAC addresses are 48 bits (6 bytes).I thought it was 8 bytes.. Are you talking about Ethernet MAC addresses?
Tuesday, 22 November 2011 - 04:15
Return Value from Function....(pointers)
sternst wrote:Quote:So..I guess, my next question....the code that I execute above is correct for swapping the interrupt table usage location?No. On the second write to MCUCR a 0...
Friday, 18 November 2011 - 15:23
Are Atmel AVR microcontrollers just for hobbyists?
Quote:The solutions for hobbyists have high e and low abcd to attain min(abcde) for hobbyist when compared with solutions for profs which have low e (price of abcd is not very...
Friday, 18 November 2011 - 14:56