Post Created date
Reading Duty Cycle with an XMEGA384C3
Change: OSC.CTRL = OSC_RC32MEN_bm; // enable 32MHz oscillatorTo: OSC.CTRL |= OSC_RC32MEN_bm; // enable 32MHz oscillatorAnd test again.
Sunday, 30 October 2016 - 08:53
DMAC: Manual errors
TRFCNT=0 means Block Size=65536  
Friday, 21 October 2016 - 15:50
Xmega ADC multiplexer problem?
jjexyy wrote: Hi freaks I find it difficult to believe that I haven't get my Xmega ADC working for 2 days already. My task is simple, I just need to sample ADC from ADCA1 of...
Thursday, 6 October 2016 - 07:12
Xmega ADC internal temperature sensor problems
This is an old thread. But according to my posts I think XMEGA internal temperature sensor with +-15C accuracy is only appropriate for 85C over temperature detection and...
Tuesday, 13 September 2016 - 06:50
Issue observed ADC channel scan during free run mode
You can use SCAN register for scanning several inputs by Channel0.
Wednesday, 20 July 2016 - 09:55
what happen when a event syeteam channel trigger a pin?
From Manual:   An event normally lasts for one peripheral clock cycle, but some event sources, such as a low level on an I/O pin, will generate events continuously. Details...
Wednesday, 20 July 2016 - 09:50
xmega interrupt vectors...
For atxmega256a3bu see "interrupt description" column of table15-1 on datasheet.   Edit: TCC0 and TCC2 interrupt vectors have common addresses:   #define TCE0_OVF_vect...
Wednesday, 25 March 2015 - 19:22
xmega interrupt vectors...
TCxy means Timer/Counter of type y on PORTx. So TCE0_INT_base is the interrupt base for a type 0 Timer/Counter which waveform pins are on PORTE.
Wednesday, 25 March 2015 - 18:54
Parts with mapped flash to data space
From AVR instruction set manual:   LDS (16-bit) – Load Direct from Data Space ... In some parts the Flash memory has been mapped to the data space and can be read using...
Friday, 31 October 2014 - 06:59
Parts with mapped flash to data space
A very special thanks to the great cliff clawson.
Wednesday, 15 October 2014 - 10:17
A note on XMEGA frequency generation mode
More experiments show that channel A toggles on TOP (moving from top to bottom). But the case is different for other channels and the related pins toggle on BOTTOM (moving from...
Wednesday, 10 September 2014 - 17:44
Switching from Mega to Xmega?
It is also important: AVcc - 0.6 is the maximum limit for XMEGA ADC reference, which makes some problems (for example, when connecting 4 wire resistive touch panels).
Wednesday, 6 August 2014 - 10:28

Pages