Type in the full discussion title or a part of it.
Discussion Title Created date
RF231 states
Hi all, I'm working with an RF231 802.15.4 radio transceiver. I can manage reception and transmission, but I have a couple of doubts about the correspondence between the protocol...
Tuesday, 31 August 2010 - 10:25
Clock configuration atxmega + rf231 via SPI
Hi all, TASK: I'm configuring the clocks in a configuration where an atxmega256a3 is interfaced to a at86rf321 radio via spi (MISO/MOSI/IRQ/CLK). RF231 data says that I can read...
Thursday, 8 July 2010 - 13:11
Setting breakpoints in atxmega devices
Hi folks, I'm trying to figure out how to set a breakpoint through avr-gdb + avarice with my mkII jtag ice, on a atxmega256a3 mcu. By reading doc avr067 I see I should use the "...
Friday, 4 June 2010 - 09:35
MAX232
Hi all, I'm trying to use the USART interface of my atxmega256a3: I've attached it to a PL2303 and I can see data going through the wire, but bytes are mapped into different...
Wednesday, 26 May 2010 - 13:25
Debugging ATXMega256A3 with avarice
Hi list. is there a way to have debug support for atxmega256a3 with avarice + MKII Jtag ICE ? I patched avarice 2.10 and was able to read fuse bits and run/stop code execution. I...
Tuesday, 11 May 2010 - 17:00
Debugging ATXMega256A3 without AVR studio
Hi all, I'm starting a project with the ATXMega256A3(MH) MCU and RF231 radio. I can compile and flash code through the JTAG interface of the AVR MKII Jtag Ice programmer. Under...
Tuesday, 11 May 2010 - 08:20

Pages