need a NC Tactile pushbutton 6mm square so i got some replies on the post also, i think its better to share that here ...
the one with 6x6mm NC from a chinese brand omten electronics.
www.omten.en.alibaba.com
in smd you...
Monday, 4 July 2011 - 10:10
schematic for sim300 is this OK i will post my complete pdf that has a atmega644 interfaced with this sim300 ... it has extra components such as two relays and a rs485 interface. please the sim300 hardware...
Wednesday, 15 June 2011 - 10:35
problems with stncmp use
char numb [9]
solved the issue.
actually i typed the declaration of numb1 and mistyped, its 1 in the code here,
regarding the space for null, i am embedding that here and C...
Encoder simple 1 channel to check ac motor stall well the proteus software has the pin 8 VCC attached to the the power internally and is not shown ...
i have got single channel magnetic encoder.. it has 3 wires i guess 1 is...
i tested it and its great u saved my life i was greatly in need of it ....
problem is that i am using Avr
so i got some replies on the post also, i think its better to share that here ... the one with 6x6mm NC from a chinese brand omten electronics. www.omten.en.alibaba.com in smd you...
i will post my complete pdf that has a atmega644 interfaced with this sim300 ... it has extra components such as two relays and a rs485 interface. please the sim300 hardware...
char numb [9] solved the issue. actually i typed the declaration of numb1 and mistyped, its 1 in the code here, regarding the space for null, i am embedding that here and C...
so after the corrections
10K and 100K would be OK i guess
can u suggest me values of both resistors i am realy weak in transister theory !
i guess this is the solution !
invert using a transistor would be good?
what should be done if it doesnt???
well the proteus software has the pin 8 VCC attached to the the power internally and is not shown ... i have got single channel magnetic encoder.. it has 3 wires i guess 1 is...
Pages