Type in the full discussion title or a part of it.
Discussion Title Created date
I didn't know you could get Ada for AVR
A little frightening, actually
Thursday, 9 May 2013 - 20:30
6.1 -- Still has the read only folder problem.
Let's see if I can produce it on command: Environment: Windows 7 ultimate 32 bit 1. Launch Studio 6.1. Wait a very long time. Aussies, go to the pub and rescue the princess. 2....
Monday, 6 May 2013 - 20:55
What's a "Toolchain?"
Having survived my blatantly obviously dumb question in the studio 6 forum, I'll rush in where angels fear to tread and ask, "What's a toolchain?" The term brings an image...
Saturday, 4 May 2013 - 21:44
Build, Rebuild and Clean
Under the build menu, are Build, Rebuild and Clean. For lack of knowing any better, I've always used Build. What do Rebuild and Clean do?
Thursday, 2 May 2013 - 19:49
2.4GHz RF - Unexpected result!
These little modules, with antenna etched onto the board get nearly twice the range of these modules with the short rubber type antenna! When used with the same, crude, hardware...
Thursday, 25 April 2013 - 21:54
ATProgram and the Elves
Just had a thought. It doesn't happen often, so I thought I'd better ask. Does ATProgram understand elf files so you can use it to write flash, eprom, fuses and the like in one...
Wednesday, 24 April 2013 - 16:01
Micro SD Connector -- Before I get these itched wrong,
Do I have this footprint reversed left to right? Pin 1 is on the left, right? The data sheet I made it from has a confusing note, and I'm not sure if it's drawn from the top or...
Tuesday, 23 April 2013 - 18:26
Good grief! Toner proof copper clad!
Second try this morning with the same result! It's the process I always use. Same material. Laminator is hot... Must be teflon or something.
Monday, 15 April 2013 - 15:45
Torby's TFT display thread
So, before you all get excited about critiquing my board, as I was wondering how to swap ports D and A so I could have analog inputs for the touch screen, I realized that I have...
Friday, 12 April 2013 - 14:06
SLOWWW ATTiny
Don't do this: Wanting to time some longish things, like 1 1/2 seconds, 15 seconds... So I had the program set the system clock slower. CLKPR = (1<<CLKPCE); CLKPR = (1...
Tuesday, 9 April 2013 - 17:33
Simulator -- Edit eprom
In the simulator, how do you edit the contents of the eeprom so the read operation reads what I want it to read? I can see what the program wrote to eeprom.
Friday, 5 April 2013 - 20:33
Downside to SMD
Been using SMD parts for a while now, and I've found a downside: I'm running out of component leads that are so handy for "green wires," test points, patching bad etched boards...
Saturday, 30 March 2013 - 13:14

Pages