Post Created date
calculate average
I will make a total program and will comeback on this issue.  
Thursday, 12 March 2015 - 15:07
ussing different registers
Thanks Clawson, Now everything makes sense. :D If I look at the location 200, and do the calculation with the number on this location it is the same as with the measured time. So...
Thursday, 12 December 2013 - 12:13
Z reg with displacement?
Quote:But surely that depends on whether Tempmes3 is located somewhere near a 256 byte page boundary? You are right :oops: I have to learn a lot thanks.
Thursday, 13 December 2012 - 12:38
Z reg with displacement?
Thanks for the quick response, I'm using the atmega328. And yes I have the instruction set always nearby. :wink: @clawson, I will try it the way you explained, but I think this...
Thursday, 13 December 2012 - 12:14
TWI problem
Here are the files that I work with now. At the end of the initmaster, I send a NACK. But when I look at the SDA patern I don't see a rising on the SDA but a spike can this cause...
Thursday, 29 November 2012 - 08:24
TWI problem
js wrote:Before looking at any code you need to make sure your hardware is ok. What are you using for the board? What is the value of the I2C pullup resistor you use? Is the clock...
Thursday, 29 November 2012 - 07:51
ADCH 6 bit instead of 8 bit
I found what was causing the problem. It was caused by the hardware. The voltage was devided after the potentiometer, so there was no more than 2.5 volt on the input of the ADC...
Wednesday, 31 October 2012 - 08:40
ADCH 6 bit instead of 8 bit
Hi, I'm sorry for the late response. I use the atmega328 and for now I use the internal 8Mhz clk divided by 8. I tried it also with the prescaler set to 128 but it gives the same...
Wednesday, 31 October 2012 - 07:05
Timer1 Compare A Handler not working
Thank you so so so very much stefan, You made my entire weekend good :D :D thanks, Patrick
Saturday, 27 October 2012 - 13:53
ADC with Atmega328
I see what you are meaning :oops: : code code... adc1: rjmp adcon1 ret And it must be like this: code code... ret adc1: rjmp adcon1 But is there a other way of multi-channel...
Tuesday, 23 October 2012 - 13:57
reading adch 5x and average
thanks Steve, For the quick response. I going to try that it sounds easy. But I still find it strange that everything works well at room temperature and start failing at 70...
Thursday, 15 March 2012 - 15:28
split up a 16 number
WrightFlyer wrote:MOV not LDI!! you want MOV what is in r16 to r23 Yep you are right!!! thanks
Thursday, 20 May 2010 - 13:44

Pages