ADC channel problem After trying to figure out what really happen, checking thru the codes, hardware I still didnt make any progress.
Only Channel ADC1 works, while the rest didn't.
One thing for...
[TUT] How to get started with microcontrollers - Part 2 Great! Thank you, its a very good tutorial, I like it and learn lots from it.
I have a question about the PWM, fading LED example.
In the code, PWM was set to phase correct mode...
ATmega168 overheated? js wrote:Quote: reset connect high. I hope NOT directly to VCC but pulled high by, say, a 10K resistor?
yes, pulled high by a 10k resistor.
ATmega168 overheated? I've definitely checked the 5v before using it.
If I connected 9v to the power rail, then would the 2.4v appear?
However, I'm still figuring what I did to it.
Hmm... I guess it's...
After trying to figure out what really happen, checking thru the codes, hardware I still didnt make any progress. Only Channel ADC1 works, while the rest didn't. One thing for...
oh ya.. mistake!! thanks =)
ok thank you.
Great! Thank you, its a very good tutorial, I like it and learn lots from it. I have a question about the PWM, fading LED example. In the code, PWM was set to phase correct mode...
Thank you for the great+detail+ easy to understand tutorial!! Really helped me!! =)
js wrote:Quote: reset connect high. I hope NOT directly to VCC but pulled high by, say, a 10K resistor? yes, pulled high by a 10k resistor.
ok thanks for advise!!
I've definitely checked the 5v before using it. If I connected 9v to the power rail, then would the 2.4v appear? However, I'm still figuring what I did to it. Hmm... I guess it's...