Post Created date
ATtiny26 has ports on in reset
How about a hardware fix, add a resistor between the port and the FET gate, then connect a diode from the reset line to the gate, so that when the reset line is low the FET is...
Saturday, 17 January 2004 - 10:53
c language "->" commando
It is a way of accessing a member of a structure when using a pointer to that structure, maybe some C guru can give you a better explanation, or maybe you should look it up in any...
Monday, 12 January 2004 - 15:06
I can't make my chip work with this code
I'll enlighten you. Stack shouldn't be needed since there are no calls. Branches and jumps don't save a return address,so as long as there are no interrupts enabled, the code...
Tuesday, 30 December 2003 - 14:09
First attempt to use GCC - make file problem
Yes, I think you need to define the device. It should be in the makefile. Maybe you should post your makefile (you'll need to rename it first I think).
Tuesday, 23 December 2003 - 10:30
#include ignored in assembler file
Dear me, It seems that you have to explicilty enable the C pre-processor with the -x assembler-with-cpp option (I might have missed a hyphen there). I don't quite understand why,...
Tuesday, 23 December 2003 - 10:26
EEPROM data embedded in HEX file
Thanks, I've found it now, --change-section-address .eeprom=0x8000
Wednesday, 17 December 2003 - 17:37
Source Code ('C' or ASM) for CLIP
I have a bunch of other PDFs relating to Caller ID spec and chips. However, I don't really want to attach them all, it might be considered bad form on this forum. Maybe somebody...
Wednesday, 17 December 2003 - 10:02
PORTx DDRx settings visa versa
Most microcontroller I/O pins default to being inputs at reset, and are consequently high impedance. There is a good reason for this; it's contention proof, i.e. it avoids damage...
Sunday, 14 December 2003 - 19:38
LANC control for SONY camera
I'd be fairly suprised if the camera did any collision detection as well, but I wouldn't rule it out. The LANC interface _can_ support more than one slave device connected to one...
Friday, 12 December 2003 - 17:29
LANC control for SONY camera
The most important thing you must do is to signal with the DDR bit. It's quite possible that the camera performs some sort or "collision" checking, and if your device is...
Friday, 12 December 2003 - 15:25
LANC control for SONY camera
A couple of microseconds either way probably won't make much difference. It all depends on how the camera samples the bits you send, it may just sample once in the centre of the...
Friday, 12 December 2003 - 13:53
LANC control for SONY camera
Just looked at your schematic, I see you already have a pullup resistor.
Friday, 12 December 2003 - 10:19

Pages