Post Created date
STK1000 u-boot not booting
U-Boot resides in 0x0 to 0x20000. So, your U-Boot should be intact.
Tuesday, 5 June 2012 - 06:59
SD driver mod for SDHC - enjoy
Thanks a lot! Your code works perfectly. However, i have one small doubt ;) why do you need to use following line gpio_set_gpio_pin(AVR32_PIN_PB08); AFAIK PB08 is noway connected...
Tuesday, 26 October 2010 - 07:20
Bug in the AVR32 framework -TWIM?
i think you should also post this in :)
Wednesday, 20 October 2010 - 06:01
do you mean slave select on cs1 is not getting selected? did you observe line physically with a scope ?
Wednesday, 13 October 2010 - 09:35
AP7000 code in external memory / linker problem
you have to write code to insert that function into sram using crt0.x
Thursday, 16 September 2010 - 11:15
Speed Of HTTP Traffic In EVK1100 Control Panel
did you try turning off all debug features in LWIP and the project too ?
Thursday, 16 September 2010 - 09:15
EVK1104 TWI Master example / working application, where?
it looks to me that twi on uc3a3256 is little different than the one in uc3b and uc3a
Monday, 12 July 2010 - 08:43
Cannot perform Chip Erase
acc. to data sheet of uc3a, it means u have a better revision than the EVK one's . Take a look at 36.10 of uc3a data sheet. i would suggest to try by lowering the clock or using...
Monday, 12 July 2010 - 08:06
studio 2.6 wifi example
do u mean u were able to detect the same with 2.5 and it doesn't works in 2.6?
Thursday, 8 July 2010 - 07:50
Problem with Gfx from tolchain216
look at your main.c it seems u have first defined there and then defined at LibGfx.c . You should define it only once.
Thursday, 8 July 2010 - 07:24
RAM global variables location
Thursday, 8 July 2010 - 07:21
How to force the address of procedure
use the following before your procedure __attribute__((__section__(".some_text"))) and locate the some_text in your custom linkerscript to the address where you want. This holds...
Thursday, 8 July 2010 - 07:18