Already using my I2C port. Well turns out cbi and sbi don't work plus 0x1F anyway, so im pulling out some LED's and changing ports.
Monday, 2 May 2011 - 23:51
Already using my I2C port. Ok, so I've had a look at the data sheet and some header files, would the code become something like this?
;***** Adapt these SCA and SCL port and pin definition to your target...
Monday, 2 May 2011 - 23:34
Already using my I2C port. Hi I have a further Question, In implementing Peter Fleurys code, There is some editing required to the s file. The code below, as well as the time delay.
;***** Adapt these SCA...
Monday, 2 May 2011 - 05:50
Already using my I2C port. After some searching, I found the I2C code by peter fleury (the one mentioned above). Anything I should know/do apart from reading up on I2C protocol more before implementing? e.g...
Monday, 18 April 2011 - 03:32
Already using my I2C port. I didn't even think of that, and it seems you're right, they are both slave devices. Woe is me. I will look into bit-banging, I'm only relatively beginnerish at microcontrollers...
Friday, 15 April 2011 - 04:24
Already using my I2C port. Unless someone has an easier/cheaper suggestion, I'm thinking of using this product, I can't see any major issues with it.
http://www.sparkfun.com/products...
Friday, 15 April 2011 - 03:24
CC2420 beginner (Atmega128) I have tried the uni technical staff, and the tech that built the boards, and would know, is on 6 months long service leave. Just my luck.
Additionally this course is a self...
Thursday, 3 March 2011 - 09:15
[TUT] [C] Newbie's Guide to AVR Timers would just like to post a thank you to dean. Your tutorial has really helped me get started with my AVR, and not having a finished PWM tutorial actually encouraged me to open up...
Well turns out cbi and sbi don't work plus 0x1F anyway, so im pulling out some LED's and changing ports.
Ok, so I've had a look at the data sheet and some header files, would the code become something like this? ;***** Adapt these SCA and SCL port and pin definition to your target...
Hi I have a further Question, In implementing Peter Fleurys code, There is some editing required to the s file. The code below, as well as the time delay. ;***** Adapt these SCA...
After some searching, I found the I2C code by peter fleury (the one mentioned above). Anything I should know/do apart from reading up on I2C protocol more before implementing? e.g...
I didn't even think of that, and it seems you're right, they are both slave devices. Woe is me. I will look into bit-banging, I'm only relatively beginnerish at microcontrollers...
Unless someone has an easier/cheaper suggestion, I'm thinking of using this product, I can't see any major issues with it. http://www.sparkfun.com/products...
I have tried the uni technical staff, and the tech that built the boards, and would know, is on 6 months long service leave. Just my luck. Additionally this course is a self...
would just like to post a thank you to dean. Your tutorial has really helped me get started with my AVR, and not having a finished PWM tutorial actually encouraged me to open up...