Type in the full discussion title or a part of it.
Discussion Title Created date
SAMD10 Analog Comparator OUT to PIN not working
I have an odd issue with the analog coparator of the SAMD10. I am not able to put out the output signal of the comparator on a GPIO pin , even though the setup is correct. I...
Tuesday, 12 May 2020 - 13:23
implicit declaration of function '_delay_ms' [-Wimplicit-function-declaration]
I created a C project for the SAMD10 MCU and have an issue that i did not have before with the same code.   I have to add that i uninstalled my previous version of ATMEL...
Sunday, 19 April 2020 - 23:59
SAMD10 datasheet TCC section question
First time i am using the TCC of the SAMD10 MCU and the datasheet in that section is a little confusing. On page 614 there is a table "Table 29-1. TCC Configuration Summary"...
Sunday, 26 May 2019 - 14:45
SAMD10 TC 32bit mode help needed
So i have been trying to understand how to use the TC in 32bit mode. According to the datasheet , it says that two TC modules are paired to achieve this. How is that working...
Friday, 3 May 2019 - 11:28
How to clear TC INTFLAG reg ? (Solved)
Hi   I am trying to use CC0 and CC1 with different values in order to toggle two GPIOs delayed from each other.   The problem i encounter is that everytime the interrupt...
Sunday, 14 April 2019 - 19:34
SAMD10 TC0 matches only once in NFRQ mode
While using the TC0 of a SAMD10 MCU in NFRQ (Normal Frequency Mode) i ran into an odd issue that i can not explain.   According to the datasheet the waveform out pin level...
Wednesday, 3 April 2019 - 13:36
math.h in SAMD project
So i would like to use the "roundf()"  function to round a float number.  So i used    #include "math.h"     to do so.  but the "...
Sunday, 21 October 2018 - 21:11
Is that how the clock system works ?
So , i have cobbled this block diagram of how i think the clocks are used in a SAMD10 MCU.   Do i understand it right or do i missunderstand something in there ?   The...
Tuesday, 2 October 2018 - 01:40
SAMD10 how to read/write from NVM / flash without ASF ?
i am looking for an example on how to read and write to the NVM without ASF.   my main intention is to read from the NVM Software Calibration Row in order to set up the...
Sunday, 16 September 2018 - 19:44
EIC CONFIG register help
I am looking for a clarification about how to use the CONFIG register of the EIC.   when one uses this : EIC->CONFIG[x].reg=...  to set up the CONFIG register , is...
Sunday, 9 September 2018 - 17:58
Considerations for using IOBUS port access ?
I was wondering if there are any considerations that one has to take in account when using  PORT_IOBUS  ?   The only thing i found is this from the datasheet......
Saturday, 1 September 2018 - 16:55
Sercom SPI Master mode SS pin location?
target MCU SAMD10:   When i enable the MSSEN (master slave select enable) bit in the SPI - CTRLB register in order to use the hardware slave select , which pin is it using in...
Tuesday, 21 August 2018 - 21:27

Pages