Post Created date
CHRISTmas Autoprogrammer Giveaway - enter here for your chance!
I'm in    
Sunday, 11 December 2016 - 13:48
ATmega328P - what to do without full swing crystal oscillator ?
ATmega328-328P datasheet in Errata section page440   Errata ATmega328/P The revision letter in this section refers to the revision of the ATmega328/P device. Rev. K 1 –...
Sunday, 13 November 2016 - 20:22
FACP - Fire Alarm Control Panel
hi CyberHype   what your try to design we call it as addressable/intelligent fire alarm system. in this fire alarm industry types of manufactures are 1) Manufactures...
Friday, 24 June 2016 - 21:18
Atmega128A Serial Programming Problem
Check your programming pins connection    Pin Mapping SPI Serial Programming is as follows for Atmega128A   MOSI PE0(PIN2)  Serial data in MISO PE1(PIN3)...
Sunday, 19 June 2016 - 23:49
problem on burning program onto atmega324 smd chip
The jagggi wrote: 4 bits of Port c were not working again. The other programs I tried (like 16x2 LCD, 4x4 Keypad, UART), none of them are working.   The 4 Bits may be JTAG...
Thursday, 14 January 2016 - 12:56
looking for moving average code
are you looking for this one   P.Ashok    
Wednesday, 30 December 2015 - 18:42
Mega48PB - Removed full swing crystal oscillator
Jacob wrote:  If you need the full-swing oscillator or need to run at more than 16MHz please contact you local sales office (Atmel of distributor): They know the special...
Monday, 14 December 2015 - 17:39
Problem with ATmega64A AU Programming
have you set the programming ISP Clock frequency to 125KHz??. you have to set ISP Clock frequency less than 1/4 of MCU operating frequency show your schematic and assembled PCB...
Monday, 12 October 2015 - 20:09
LCD trouble between HD44780 and ST7066 controller
Hi you may require to set some jumper and resistor on LCD Module as per the   P.Ashok
Wednesday, 12 August 2015 - 12:01
AVR ISP MKII Programmer problems!
avrdude is trying to open the default serial port to talk with AVRISP mkII but AVRISP mkII is USB Device so you have to add  " -P usb " Command and also you have missed...
Sunday, 9 August 2015 - 19:40
Metal Oxide Varistors burns out
Kartman wrote: Having blown up many protection devices, i consider myself an expert! MOVs tend to degrade, so if you have lots of small transients it is death by 1000 cuts. If you...
Thursday, 19 February 2015 - 14:42
Metal Oxide Varistors burns out
ok we will try to get  MOV Details.   what is normal voltage deviation on mains power supply in USA      
Thursday, 19 February 2015 - 10:53