Type in the full discussion title or a part of it.
Discussion Title Created date
Loading a binary file using AS6 (???)
Hi All Older versions of AVR32 studio allowed loading a binary file by specifying an offset (0x80000000). AS6 doesn't look to support binary anymore. Problem is that I have binary...
Wednesday, 19 September 2012 - 18:15
AS6 target - missing target ELF selection
Hi All Just linking to a couple of possible improvements for AS6 which have caused some problmes: - target names like "abcd1.3.elf" don't work (one needs to rename the output to "...
Wednesday, 29 August 2012 - 19:39
EVK1105 IPv4/IPv6 Dual-stack on line
Hi All I have just release uTaskerV1.4-6 for AVR32 and put an EVK1105 running IPv4/IPv6 dual-stack on-line showing its operation: - To contact the boardover IPv4 the following...
Monday, 6 August 2012 - 10:03
Linking to a specific address using AS6
Hi All If one is using AS6 without an external make file, what is the method to link a project to an address other than the standard start address? Eg. link to 0x80000800 rather...
Tuesday, 3 July 2012 - 21:07
uTasker Boot Loader for AVR32
Hi All The following new video shows the uTasker boot loader operating on the AVR32 EVK1100 board: http://youtu.be/e7JvWodljlc This allows fast and reliable remote SW updates via...
Monday, 9 January 2012 - 03:23
AVR32 FTP Client
Hi All The following new video shows a demonstration of embedded FTP client operation in the uTasker project: http://youtu.be/sZOCFLDfGTk It is not shown running on an AVR32 board...
Monday, 9 January 2012 - 03:18
AVR Studio 5 - binary programming and connecting to target
Hi All I am using AVR Studio 5 and haven't been able to work out how to do the following operations: 1 - load a binary file using "AVR Programming" In the older environment it was...
Monday, 9 January 2012 - 03:13
External Interrupt 0 on UC3C
Hi All I have just started with the EIC in the UC3C after using it previously in the UC3A and UC3B. The previously used devices have a single interrupt group for these (External...
Saturday, 17 September 2011 - 01:08
Can one kill an AT32UC3C0512C with Studio 5?
Hi All I have just bought an AT32UC3C-EK (quite expensive and a shame that it doesn't have Ethernet connected, but the reason was for a CAN project). Using Studio 5 I loaded some...
Friday, 2 September 2011 - 22:33
USBB Difficulty
Hi All I am working with UC3A and UC3B parts with USBB controller - [USB device mode]. The following effect is consistent (using a new driver and not from framework - the...
Sunday, 26 June 2011 - 01:00
JTAGIDE MkII not working with Studio 5
Hi All I can program the AVR32 (UCA0512) with "avr32program" without any problems, but no chance of doing anything from Studio 5. The following is the error message: Quote:Unable...
Wednesday, 22 June 2011 - 08:54
External make files
Hi All Has anyone used an external make file with Studio 5? I had a try by setting a path to such a make file (I didn't study the restrictions listed but wanted to see what it did...
Saturday, 18 June 2011 - 22:28

Pages