Post Created date
Studio 4 and code versioning system
All sound advice - thank you. I guess I'll look into using CVS for my "Tiny" programs. I really don't have plans for large processors or large code projects, so I was looking...
Thursday, 8 October 2009 - 21:34
Studio 4 and code versioning system
Thanks Arnold. You describe what I remember of the S/W dev environment with a dedicated version control system. I don't really want to go that way, so you're right - I don't like...
Tuesday, 6 October 2009 - 23:02
How to disable Pull Up on on ATTiny10 PB3
Update: Resolved Atmel support pointed to the reset jumper on the STK-600. The stk-600 has it's own pullup for RESET. To sum it up: 1. Reset Disable eliminates one source of pull-...
Tuesday, 6 October 2009 - 18:30
How to disable Pull Up on on ATTiny10 PB3
Sorry guys, I did leave out the IO init: ; Initialize I/O (Page 52) ldi R16,0b00000001 ; PB3=Input,PB2=Input,PB1=Input,PB0=Output out DDRB,R16 ; DDRB=...
Friday, 2 October 2009 - 15:40
How to disable Pull Up on on ATTiny10 PB3
Glitch, I do the same setup using ADC2 and ADC3: ; Initialize ADC (Page 94) ldi R16,0b00000000 out ADCSRB,R16 ; Single Convert mode ldi R16,0b00001100 ;...
Friday, 2 October 2009 - 00:18
How to disable Pull Up on on ATTiny10 PB3
Anyone have any ideas on how to tri-state this pin? I've heard nothing from Atmel support.
Thursday, 1 October 2009 - 21:08
How to disable Pull Up on on ATTiny10 PB3
No - the Tiny10 uses a "TP1" programming interface. That works fine with or without the reset disabled on the STK600. I had to disable RESET because I use PB3 for a pushbutton...
Wednesday, 30 September 2009 - 19:38
How to disable Pull Up on on ATTiny10 PB3
Right theusch. I put a 10K to ground and it went to 2.4 V and a 100K went to 4V showing there is a 15K-20K pullup somewhere. I did set the RSTDISBL fuse.
Wednesday, 30 September 2009 - 19:00
Assembler handling of Z reg and .db tables
Lee, Thanks. Now I don't feel so bad - just a newbie falling into the same old traps that affect most users. Bob
Thursday, 6 August 2009 - 11:17
Assembler handling of Z reg and .db tables
I was wondering if/when you would jump in Lee. Being a newbie, I rely on the documentation. The data sheet and the AVR 8-Bit instruction set manual are two documents that show the...
Wednesday, 5 August 2009 - 18:50
Assembler handling of Z reg and .db tables
Thanks Steve. I agree it should have worked but I did not spend the time on what was going on. The MAPPED_FLASH_START macro is a much better solution than the hard coded 0x40. The...
Wednesday, 5 August 2009 - 15:06
Assembler handling of Z reg and .db tables
Clawson, Although I grew up in assembler, I am guilty as charged in AVR land. By your statements, I'm assuming the Z reg works as documented on other platforms. The only thing I'm...
Tuesday, 4 August 2009 - 23:13

Pages