Type in the full discussion title or a part of it.
Discussion Title Created date
Full Swing Crystal issue
I m trying full-swing feature of ATmega328P in hope for increase robustness against possible noises. . I have no problem with low-power mode over years of production, this is my...
Fri. Nov 23, 2018 - 05:13 PM
atprogram command for ATtiny816 fuse bits
I am trying to program ATtiny816 using Atmel-ICE from command line   I can erase/write flash/lock bits using command line sucessfully :  atprogram -t atmelice -i UPDI -d...
Wed. Apr 25, 2018 - 08:13 AM
ATmega328P decoupling Vcc using Ferrite Bead
I tried decoupling Vcc as recommended in AN2519 : Figure 2-2    my PCB is as recommended in appnote, MCU is decoupled from Vcc using ferrite bead and 100nF cap close to...
Wed. Feb 14, 2018 - 03:03 PM
ATTiny816 UART 250kbps accuracy
My old circuits use ATmega88 , 16MHz crystall, UART 250kbps, 8bit , 2 stop, no parity, both RX and TX   ATtiny816 has inetrnal 16Mhz and 20MHz RC factory calibrated with...
Fri. Jan 5, 2018 - 03:03 PM
ATtiny816 UART example
hi  I am trying to use UART of ATtiny816 datasheet is lack of examples,   could anyone show some reference for me ?   thanks
Wed. Jan 3, 2018 - 03:03 PM
EEPROM corrupt or damge in BOD ?
hi    I know this is discussed several times before, I have read most of very useful old threads, and did my project as below:   my circuit is 4.5V BODLEVEL set to...
Wed. Dec 27, 2017 - 09:09 AM
ATmega328p UART framing error does not occur!
There is a protocole over serial port as following: 1. no signal (idle) is High (+5V). 2. reset signal is a 60 us Low (0v) pulse. 3. data signal is : 250 kbps/8 bits/2 stop/no...
Sat. Jun 24, 2017 - 02:32 PM