Post Created date
info on crystal use
MarcBrule wrote:So if I have a 4.000 MHz crystal with a load capacitance of 20pf and a stray capacitance of 7pf (from datasheet), then I would use two 27pf caps to achieve and...
Tuesday, 22 March 2005 - 03:56
HD44780 LCD initialization problems
Sean, Not sure how good my eyes are here :shock: , but from your picture it looks like you've got your data pins wrong. It looks like you've got your 4 bit data bus connected to...
Thursday, 10 March 2005 - 03:07
Mega32 as a USB Slave
Hey Freaks, How do you set the baud rate / flow control on the FTDI? Im guessing is via the USB interface but I can 't see it written anywhere. Do you need the external EEPROM to...
Tuesday, 25 January 2005 - 01:38
MEGA48 seems to "forget"
Hi, Place a 100nF cap between your reset pin and ground (leave the 10K) . Its possible that it wasn't resetting properly with just a 10K pullup. Your programmer may have been...
Thursday, 13 January 2005 - 21:51
Video Frame Capture using AVR and ADC
Hi Pete, What a GOOD question! Check this out Dave
Monday, 10 January 2005 - 03:28
[Mega128] How can i write a delay loop for perfect timing?
And remember to keep your fingers crossed that you don't get any interrupts....
Thursday, 2 December 2004 - 22:47
Wireless lan
blueled wrote:Does anyone has any experience with the lantronix wi-port connecting it to a atmega ?. Yes. What is your question? Dave.
Monday, 29 November 2004 - 01:22
OT- Wireless RS232 Connection - Premade Module Suggestions
Hi, Check out the WiPort from Lantronix. Its a serial to WiFi gateway. Really easy to use. Dave.
Tuesday, 23 November 2004 - 01:56
how safe is it to sink current from LED without resistor?
bschiett2004 wrote: I want to get as much current as possible through the LEDs. Connect the led directly to your bench power supply and crack up the voltage. You'll definately...
Tuesday, 23 November 2004 - 01:37
AVR Avaliability in Australia?
Memec... Cheers Dave.
Monday, 22 November 2004 - 02:14
USB to Serial Converter
Well I re-installed the drivers and everything works perfectly!! :lol:
Tuesday, 9 November 2004 - 01:25
USB to Serial Converter
So how do i go about talking to my serial device through a terminal emulater such as Hyperterminal? It still just gives me the option of connecting to comm1 or tcpip??
Tuesday, 9 November 2004 - 01:06