Polarity Insensitive Serial Comms Scroungre wrote:Nah, full differential would work fine, if the grounds were isolated. S.
With the circuit I posted? if the bridge was driven from a differential line...
Friday, 10 December 2021 - 19:00
Fuses - How Do They Work? Agreed. I think "non-volatile configuration bits" would be a good phrase to describe them.
Friday, 10 December 2021 - 00:07
Polarity Insensitive Serial Comms jgmdesign wrote:I think y'all need to take a BIG step back and start clicking the links the OP left in post #34.
Ouch, that made my head hurt. I guess I have nothing...
Friday, 10 December 2021 - 00:02
Polarity Insensitive Serial Comms
Scroungre wrote:Anything wrong with running the signal through a full-bridge rectifier? They're cheap, and fast enough. S.
digitalDan wrote:
Full wave...
Thursday, 9 December 2021 - 19:53
Polarity Insensitive Serial Comms Full wave rectify with a schottky bridge into an opto-isolator?
Edit: would only work with single ended signal. True differential would be a no go.
How to fix low LED light? DocJC wrote:
Or, if it is connected to a micro's I/O pin, then perhaps the internal pull-up resistor was activated instead of making the pin an output.
JC
+1
Tuesday, 13 April 2021 - 10:21
Controlling voltage to components bobioknight wrote:Hello, I am building a circuit using a ATTiny, a 1.3 oled color screen, and two AAA batteries. The batteries provide enough power to run the circuit, but they...
Adjusting LCD contrast by PWM david.prentice wrote:The contrast depends on VCC. It will not alter with the moon or daylight. You set once and forget.
I agree with the first two...
Scroungre wrote:Nah, full differential would work fine, if the grounds were isolated. S. With the circuit I posted? if the bridge was driven from a differential line...
Agreed. I think "non-volatile configuration bits" would be a good phrase to describe them.
jgmdesign wrote:I think y'all need to take a BIG step back and start clicking the links the OP left in post #34. Ouch, that made my head hurt. I guess I have nothing...
Scroungre wrote:Anything wrong with running the signal through a full-bridge rectifier? They're cheap, and fast enough. S. digitalDan wrote: Full wave...
Full wave rectify with a schottky bridge into an opto-isolator? Edit: would only work with single ended signal. True differential would be a no go.
N.Winterbottom wrote:Also What is N76E003AT20 ?
DocJC wrote: Or, if it is connected to a micro's I/O pin, then perhaps the internal pull-up resistor was activated instead of making the pin an output. JC +1
bobioknight wrote:Hello, I am building a circuit using a ATTiny, a 1.3 oled color screen, and two AAA batteries. The batteries provide enough power to run the circuit, but they...
Does your model UC3 have GPLP registers?
david.prentice wrote:The contrast depends on VCC. It will not alter with the moon or daylight. You set once and forget. I agree with the first two...
westfw wrote: Are you saying this can be done even when the lockbits are set on the bootloader (I assume the chip has this facility?) Mega0 doesn't seem to have lockbits in the...
My read of the data sheet suggests that the bootloader sets the BOOTLOCK bit in NVMCTRL.CTRLB register if it wants the bootloader section to be protected. I guess they leave...
Pages