Type in the full discussion title or a part of it.
Discussion Title Created date
rs 232 connection to stk 500
Hi, Got a newbie question. To connect the spare rs232 port on the stk 500 to the computer, should I use a modem cable, or a straight-thruough cable. Do the Rx and Tx lines need to...
Tuesday, 24 February 2004 - 04:17
[ANN] Salvo RTOS for IAR AVR C Now Available
Just a quick note to mention that Salvo for AVR and MegaAVR v3.2.4 has been released and is available on our website ... this is the first release to fully support IAR AVR C (EW...
Tuesday, 24 February 2004 - 01:14
[ANN] Salvo RTOS for IAR AVR C Now Available
Just a quick note to mention that Salvo for AVR and MegaAVR v3.2.4 has been released and is available on our website ... this is the first release to fully support IAR AVR C (EW...
Tuesday, 24 February 2004 - 01:13
Some basic code, right or wrong
Hi, i am a starter with AVR microcontrollers so i chose to write something in basic, i think the code i wrote is full of @!#$ and i want to learn something from it, it`s the code...
Tuesday, 24 February 2004 - 00:31
SPI HELP Plz
Hi, I'm trying to interface between the AT43USB355 processor and a data-flash card(AT45DCB002) using SPI. All I want to do is write to and retrieve from a specific location. Sound...
Tuesday, 24 February 2004 - 00:31
SPI HELP Plz
Hi, I'm trying to interface between the AT43USB355 processor and a data-flash card(AT45DCB002) using SPI. All I want to do is write to and retrieve from a specific location....
Tuesday, 24 February 2004 - 00:28
opto isolated mosfet motor driver
Hi! I need to drive 10A 12V motor using PWM from Atmega8. I have read that PWM frequency should be above 20kHz in order to avoid the noise so I would like to use it. Could...
Tuesday, 24 February 2004 - 00:22
AVR ISP damaged my micro
I am using the AVRISP to program my ATmega16 in system. I have tried 3 times and each time my micro became damaged upon the first programming. I am using the 10-pin connector...
Monday, 23 February 2004 - 23:35
Connecting a VFD to a MEGA8L
I would like to interface a VFD to a MEGA8L microcontroller using 4-bit bus. PortD is the databus and 3 pins of PortB are used as the control signals. Any idea.
Monday, 23 February 2004 - 22:36
Accessing MultiMediaCard memory?
Hello! Has anyone used the AVRs to access MultiMedia Cards? Supposedly they have a very easy serial interface... but I wouldn't know where to begin on such a project. I assume...
Monday, 23 February 2004 - 21:41
Learning Documentation
Does anyone have any recommendations for documentation (books) to purchase to learn more about writing code for beginners. Examples of "hands-on" applications and examples would...
Monday, 23 February 2004 - 21:24
CANNOT INSTALL SERVICE PACK 1
I just downloaded Service Pack 1 for Studio 4, and it won't install. I ran Install once and it says that it installed, but when I check "Help" "About" in Studio 4, it still says I...
Monday, 23 February 2004 - 20:42

Pages