Dallas one-wire interface

Spamiam's picture
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0



Dallas One-Wire low-level and high-level interface. The technique to address the physical I/O pins is tailored to the Oak Micros OM128 device, but more standard pin addressing can substituted easily. The timing was carefully measured to meet the 1-wire standard. Changes to the pin addressing may change the speed (probably ending up slightly faster), and this could affect the most time-critical functions.

Also, it is tailored for 14.7MHz, but there are comments on the clock counts for certain sections so that macros could be added to calculate the actual times.