Want a dataflash tester?

1 post / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

To test the AT45xxx Series Dataflash devices (along with SMT soldering) I designed the simple boards shown below. I ordered 5 pcbs but pcbcart sent me 28 of them, so I have a few extras. If anyone is interested I can put together the extras for $6 USD each (basically the cost of the parts).

Pictures of the board. I can send it with or without the pin header. The dataflash is the AT45DB321D-MU (approx 4MB).

The only thing to note in the schematic is that the RESET pin is not exposed at the header. So when powered, it is always "on" (although in a low power standby mode). I did this to match the design of the main board I'm working on.

Send me a PM if you are interested.

Attachment(s): 

-Brad