Using ESP-01 and Arduino to creater Browser controlled Servo mechanism

Go To Last Post
4 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hello everyone, 

I have an ESP-01 along with an Arduino Uno . What I want to do is allow a device to connect to the ESP01 and through a sort of browser interface (a couple of buttons or so), be able to control the GPIO on the Arduino. I am a beginner in terms of using wifi modules.

Any tutorials/documentation would be apppreciated.

Thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Why do you need the Uno? The esp01 should be able to do it alone. Surely someone has done what you want already?

[edit] i didn’t need to look too hard! https://www.roboremo.com/esp8266-servo.html

Last Edited: Thu. Jul 4, 2019 - 01:39 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Well, i need to use an arduino shield to integrate it with other stuff as well, instead of just a servo. The servo is just me testing stuff out

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

If you want a good answer - ask a good question. Don’t ask for a servo then say you want something different.
Again, I’m sure that someone has done something similar to what you want - Google is waiting for your request.