I am using AVR Burn-O-Mat to program Atmega8 via USBasp. I just changed my fuse-bits to attach external oscillator but I think that bits where wrong and now usbasp is unable to program it. I was using Atmega 328 data-sheet to set fuse bits. Is fuse bits setting of both controller are same? I just found that it is not. and now i am in a big trouble can someone tell how to change my bits again ? or any solution to restore it here is pic of fuse bits I set.
Joined: Wed. May 30, 2018
Posts: 47 View posts
Last Edited: Tue. Jul 3, 2018 - 06:40 PM