Hello to all......
I have one sensor which gives data through RS-485...I used atmega32 and max485 to read the sensor data...I have used isp programming to program atmega32...(using parallel port)...Now I am facing strange problem...I program the chip connecting ISP cable...after programming it starts the program , it works ok....but when I remove ISP cable and restart the program it does not work properly...it works ok only when ISP cable connected...after more digging I found that MISO, MOSI and SCK either of the three pin is coonected , it works ok...how to solve this if I want to run program without ISP cable connected...
strange problem,,,,,,ISP.
Author
Message
are you trying to power the project using the parallel port? YOu might also want to look for ground loops.
JIm
I don't power it form parallel port,,,I don't find any ground loops...my miso,mosi,sck lines are open..I mean it only connectes during programming , else kept open...should i put there something?
gosh!......this smps adaptors....I hate them....changed to reliable power...it works..don't use this adaptors....