Running the program while JTAG is connected

Go To Last Post
2 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi,

I've got an USB Key evkit and now I wanna play with it. I can program it just fine with the dragons JTAG (I also tired the Flip thingie, not musch succes). However, to run the program, I have to physsically disconnect the JTAG from the evkit. This is discomfortable. Is there any way to allow execution of the program, while the JTAG is connected?

(PS: I have googled before asking, didn't find anything useful, if it has been discussed, I don't know the correct keywords to google for).

Thanks,

David

There are pointy haired bald people.
Time flies when you have a bad prescaler selected.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Let us see if my experience helps you.

I use the dragon and avr studio to download the program.
I had the same problem. I had to disconnect the dragon physically, to make my target board go to run mode.

Then I discovered, if you just kill the AVR dragon window (which you used just now to download the program - by clicking on that little x at top right corner), target board goes into run mode.

Good luck !!