Remember to remove a Serial ICSP when done programming

Go To Last Post
3 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Dammmm :oops: :oops:

Just wasted 1.5 hours , because my Olimex M32 board didnt work when i had programmed it with an Olimex Serial programmer & PonyProg (The latest 6.0c Beta) i think it is called.

Thought i was figthing fuses , or the short circuit.

But found out that the Programming Dongle kept reset low :cry: :cry:

Well this is just a hint to other serial programming users.

Start by having a look at Reset , if it is LOW , then dont look further :oops:

Btw: I did the reverse diode trick on my 7805 regulator , and it seems that all is working fine.

/Bingo

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Sorry, (newbie to AVR here) what is the "reverse diode trick" on your regulator all about? Are you trying to prohibit reverse current flow for some reason?

Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Please edit thread to..."Remember to remove a "junky" Serial ICSP when done programming"
:)

John Samperi

Ampertronics Pty. Ltd.

https://www.ampertronics.com.au

* Electronic Design * Custom Products * Contract Assembly