programming Atmega644PV

Go To Last Post
5 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi,

does anyone know which pins I have to use on the mega644pv to program it, I know its usually the SPI pins. Oh I'm using the stk500 via the ISP connector.
I know for my 2561 I used the PDI,PDO pins but I dont see those here.

Is it the SPI pins? Just don't want to start off on the wrong foot.

Thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Did you try reading the datasheet?

Regards,
Steve A.

The Board helps those that help themselves.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Of course and I do believe it's SPI, I just wanted to make sure I dont make a stupid mistake with the hardware.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Quote:

Did you try reading the datasheet?

Quote:

Of course and I do believe it's SPI, I just wanted to make sure I dont make a stupid mistake with the hardware.

What does the datasheet section entitled "Serial Programming Pin Mapping" say?

[or you don't believe what the datasheet says, and would rely on our affirmation?]

Lee

You can put lipstick on a pig, but it is still a pig.

I've never met a pig I didn't like, as long as you have some salt and pepper.

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Confirmed! ty