olimex avrmt128

Go To Last Post
4 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I just got one of these neat little boards for about $50... it has 5 buttons and an lcd and a mega128 and an RS232.... theres a picture of it in the companies section... does anyone else have one? Has olimex given out any source (they have the schematic on their site). There is a program in it from the factory, but I'm just about to put my own in it. I use iccavr mostly.

Imagecraft compiler user

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hello Bob,

I am also purchased this board.
Did you succeed to pur any code other than demo code ?

I am not.
I am even can't to connect the board with AVR JTAG USB and AVR studio 4.
JTAD ID can't be recognized.

Do you have the same problems ? Or other ?

Regards,
Radislav

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I have several MT128 programs. In fact, you will notice that my iccv7avr version of the mt128 demo is posted on the olimex site! World famous I guess. What voltage are you using? It will take AC OR DC, but it needs to be > than 7 volts to run the regulator.

Imagecraft compiler user

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

My board is AVR-MT-128.
I am using 12 vdc laboratory PS. On Vcc pin a have 5.05 v.
I am also tryed direct 5v Vcc/Gnd connect to Vcc/Gnd pins on header.