again I'm sitting on a new board this time with an Xmega and an AVRJTAGICE MK2. And I was wondering why the controller isn't reset after the re-programming. I was used to the behaviour of the AVRISP MK2 which I just could leave plugged to the board, program and then the new code starts. This doesn't work with the current configuration, I have to unplug the ICE and powercycle the board to start the code. Why is that ? I'm not sure about the reset thing at the JTAG and I should mention that I'm using a reset-controller on the board. Is it possible that the ICE actually tries to reset but can't pull down the line ?
Thanks very much for your hints and comments