Just got my Dragon yesterday.
It appears that there has been a board revision.
The Dragon board I have is slightly different from all the other photos I've seen. (See attached photo).
I highlighted the obvious differences.
Anybody know what all has been updated?
I guess I'm curious if the new revision is a bit more robust than earlier versions.
Also, just wondering if anybody has found a case that has mounting standoffs that align with the new holes in the PCB.
I'm not planning on using the prototyping area so I'm looking for a fully enclosed case.
I found a blog where a guy notes a case that fits the PCB perfectly, except the standoffs don't align with the new holes in the PCB.
This case is really nice because you can get it in a translucent so that you can still see the LEDs.
Just wondering if anybody else has found anything better.
If not I'll get the translucent Serpac H-65 from Digi-key and glue in some new standoffs.
Note: for all you guys that want/need to use the prototyping area or use a ZIF, you can get this case with a battery compartment opening.
The sides of the case will have to be cut as a ZIF is bigger than the case is wide but it still might work and be a nice solution to keep everything covered when not in use.