MicrochipStudio editor window residing outside main window

Go To Last Post
5 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Hi

I moved an editor window of my project to my second monitor. Now I want to move it back inside the MicrochipStudio main window, but every time I try that MicrochipStudio freezes for a few seconds and  then crashes. After restarting the Studio again my edit window is still outside of the main window. Any idea how I can get it back?

 

MicrochipStudio V7.0.2542

Win10 NT6.2.9200.0 Platform Win32NT

 

Klaus

This topic has a solution.

Klaus

Last Edited: Sat. Feb 27, 2021 - 03:46 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0
  • Does opening a new file for editing also result in a detached code editor ?
  • Does AS7 MS7 also crash if the detached editor is first moved onto the same monitor as AS7 MS7 main application window ?

 

Last Edited: Sat. Feb 27, 2021 - 10:26 AM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Top Tips:

  1. How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillatorhttps://www.avrfreaks.net/comment...
  5. When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
  6. Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...
This reply has been marked as the solution. 
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 1

Thanks awneil

 

that solved the problem

Klaus

Last Edited: Sat. Feb 27, 2021 - 11:00 PM
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

klaus1311 wrote:
that soved the problem

You're welcome. Please mark the solution - see Tip #5 in my signature, below:

Top Tips:

  1. How to properly post source code - see: https://www.avrfreaks.net/comment... - also how to properly include images/pictures
  2. "Garbage" characters on a serial terminal are (almost?) invariably due to wrong baud rate - see: https://learn.sparkfun.com/tutorials/serial-communication
  3. Wrong baud rate is usually due to not running at the speed you thought; check by blinking a LED to see if you get the speed you expected
  4. Difference between a crystal, and a crystal oscillatorhttps://www.avrfreaks.net/comment...
  5. When your question is resolved, mark the solution: https://www.avrfreaks.net/comment...
  6. Beginner's "Getting Started" tips: https://www.avrfreaks.net/comment...