MCP2510/5 Unable to put into Normal/Loopback mode

Go To Last Post
2 posts / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

Anoyone with experience of this SPI CAN controller from Microchip?

I ?think? I did everything right to configure the device, but when I try to put it into normal or loopback mode, it does not comply, but stays in config mode.

Is there a specific reason for this ? Am I missing some specific register initialisation during config mode ?

Any hints would be appreciated.

Regards
Pieter Conradie

  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

send me the datasheet (pdf). I will try to check it out.
joachim