LWMesh: Stack command endpoint

1 post / 0 new
Author
Message
#1
  • 1
  • 2
  • 3
  • 4
  • 5
Total votes: 0

I'm using the "Atmel Wireshark Sniffer Interface" and I'm seeing packets with source and destination endpoint = 0 (Stack command endpoint).  And sometimes get a packet with either source or destination endpoint = 0 and the other !=0

I have not enabled AODV routing by not including #define NWK_ENABLE_ROUTE_DISCOVERY

 

Are there any other stack commands that can happen besides route discovery?  If not, the sniffer must be screwing up, and/or I'm getting bit errors because I'm using metal tape as my shield right now, which has very "hit or miss" performance, and I'm using a board that is probably a "miss".